How To Put Riser Visor Back On Eureka Easy Clean Vacuum
- Bottom Cover 4 steps
- Belt one pace
Action Shots
Be an action hero! This guide needs images that amend demonstrate how to perform specific actions.
Featured Student Guide
This guide has been the difficult work of our awesome students and is found to be exceptionally cool by the iFixit staff.
Introduction
Sometimes, the chugalug in the vacuum can become bad or even only come loose. In order to properly maintain your vacuum, it'southward of import to know how to replace the belt. This guide covers the necessary steps for a successful replacement. Make sure your vacuum is off earlier attempting whatsoever replacements.
-
-
Unscrew the two xviii.1 mm PH2 Phillips caput screws on the bottom of the vacuum.
-
-
-
Pry off the Riser Visor using the plastic opening tool.
-
-
-
Remove the screw cap using the metal spudger.
-
-
-
Unscrew the 14mm PH2 Phillips head spiral.
-
Pull the bottom cover off of the balance of the casing.
-
-
-
Pull the roller, motor, and belt out of the casing.
-
Separate the belt from both the roller and the motor.
-
Most done!
To reassemble your device, follow these instructions in reverse gild.
Conclusion
To reassemble your device, follow these instructions in reverse order.
Team
One Comment
Source: https://www.ifixit.com/Guide/Eureka+EasyClean+71C+Belt+Replacement/100551
Posted by: adamsmeman1981.blogspot.com
Hello would y'all know what belt number this would utilize? I take looked everywhere. I would appreciate it
vdean4b - Answer